FAG 7408 -B-MP-UA Angular Contact Ball Bearing - 40 mm ID, 110 mm OD, 27 mm Width, Normal Linear Bearing full-width-section li { margin-bottom: 5px

full-width-section li { margin-bottom: 5px

Superior design requires 20% less force to cut

the components of the TMIC 7-28 kit are built to last

The ball joint puller with lever translation of the series 129 is used for pressing out the ball pins when removing ball joints as well as tie rod ends on tie rods

heavily loaded applications where strong film protection is needed

FAG 7408 -B-MP-UA Angular Contact Ball Bearing - 40 mm ID, 110 mm OD, 27 mm Width, Normal Linear Bearing full-width-section li { margin-bottom: 5pxAngular Contact Ball Bearing Angular Contact Ball Bearings have raceways in the inner and outer rings that are displaced relative to each other in the direction of the bearing axis. They are designed to accommodate combined loads. Manufactured to precision tolerance class for demanding applications. Suitable for use in a wide range of industrial applications where reliability and performance are essential.