JTEKT-KOYO NAXK30-Z Needle Roller/Axial Ball Bearing - 30 mm ID, 48 mm OD, 30 mm Width Heater reduces bearing wear

reduces bearing wear

Scratch-resistant exterior and anti-fog interior for optimal visibility

Low (Spot)

allowing you to quickly remove material from the work piece

The bell-shaped hydraulic ball joint puller of series 128-H is used to press out the ball pins when removing ball joints and tie rod ends on tie rods

JTEKT-KOYO NAXK30-Z Needle Roller/Axial Ball Bearing - 30 mm ID, 48 mm OD, 30 mm Width Heater reduces bearing wearNeedle Roller Axial Ball Bearing JTEKT KOYO needle roller axial ball bearings combine a needle roller bearing for radial loads with an axial deep groove ball bearing for axial loads, giving compact support in two directions in a single bearing.