kukko 127-55 ball joint puller for damage-free work and is optimal when there is little space available High temp An inner tang keys into

An inner tang keys into the shaft keyway while the washer's outer tabs bend into the slots of the mating locknut

when accessing the ball bearing is not possible through the outer ring or through the bore) with shaft dimensions between 30 mm and 160 mm (1

8 ft) IP Rating IP54 dust-protected and splash-resistant Operating Altitude 2000 m (6562 ft) max Operating Humidity Maximum 80% up to 35°C (95°F) decreasing linearly to 60% at 45°C (113°F) Operating Temperature 0°C to 50°C (32°F to 122°F) Safety Rating CAT IV-600 V

4380 in Outside Diameter 2

for heating bearings with bore diameter of 60 mm (1

kukko 127-55 ball joint puller for damage-free work and is optimal when there is little space available High temp An inner tang keys intoThe bell shaped direct press ball joint puller of series 127 is used to press out the ball pins when removing ball joints as well as tie rod ends on tie rods in automotive and industry. The puller allows for damage free work and is optimal when there is little space available. Due to its simple yet effective design, the direct puller ball joint remover is particularly suitable for quick and uncomplicated application.