K+M Carbide Cutting Pilot w/Flutes, 26 Calibre/6.5MM Cleaning Rod Calibre_.375 Calibre yet controlled expansion

yet controlled expansion

This result was made possible by Lapua’s consistent quality that starts with the raw materials of the bullet

for all compatible cases

001" smaller than the bullet diameter with an estimated

Consistent

K+M Carbide Cutting Pilot w/Flutes, 26 Calibre/6.5MM Cleaning Rod Calibre_.375 Calibre yet controlled expansionThis finely ground carbide cutting pilot, designed for use with the K+M case neck turning body, has four cutting flutes used to remove the doughnut that can form at the inside neck wall and shoulder junction. If you are noticing the formation of a doughnut, this tool will remove the excess material without affecting inside neck diameter allowing for uniform bullet seating and eliminate powder gas restriction. There is also less friction between brass